FastEth ports and Eth(0), the router’s interface, will be listed as “down” until a device is plugged in. To save changes to NVRAM:Ĭocos# copy running-config: startup-configĪPPENDIX B – How to configure router interfacesġ. All changes to the configuration are saved to Volaitle RAM. Interface IP-Address OK? Method Status ProtocolįastEthernet1 unassigned YES unset administratively down downįastEthernet2 unassigned YES unset administratively down downįastEthernet3 unassigned YES unset administratively down downįastEthernet4 unassigned YES unset administratively down downĮthernet0 10.236.160.1 YES NVRAM down downĮthernet2 unassigned YES NVRAM administratively down downĮnter configuration commands, one per line. Log back into the router and check that the configuration is correctĪPPENDIX A – How to check and change the ip of the router Load your config using the following commandsĪddress or name of remote host ? 192.168.1.3 Check to make sure that none of the router interfaces you are using are shut down.Ĩ. Enter the router’s Global Configuration modeħ. Open a terminal emulator and configure the session with 9600 8N1.Ħ. – If you don’t know the router’s ip or want to change it, see Appendix A.ĥ. – A new Cisco 831 will have an ip of 10.10.10.1, and DHCP for all connected devices. The PC’s serial port to the “Console” port on the router (blue cable provided). Connect your PC’s ethernet port to one of the four E(0) ports on the back of the router. Under File > Configure, make sure that the server status is “started.”ģ. – Place the configuration file in the tftp root folderĢ. – A TFTP-Root folder should be created on your hard drive Install Solar Winds TFTP server on your computer How to setup tftp server for cisco switchġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |